BlueWalker VFI 2000CRM LCD Specifications

EN Online UPS PowerWalker VFI 1000CRM LCD PowerWalker VFI 2000CRM LCD PowerWalker VFI 3000CRM LCD Manual Uninterruptible Power Supply S

7 EN 3. Operations 3-1. Button operation Button Function ON/Mute Button  Turn on the UPS: Press and hold ON/Mute button for at least 2 secon

8 EN Display Function Remaining backup time information Indicates the remaining backup time in pie chart. Indicates the remaining backup time

9 EN 3-3. Audible Alarm Description Buzzer status Muted Battery Mode Sounding every 4 seconds Yes Low Battery Sounding every second Overload Sou

10 EN 110: presents output voltage is 110Vac 115: presents output voltage is 115Vac 120: presents output voltage is 120Vac (Default) 127: presents o

11 EN in parameter 3 is from -3V to -12V of the nominal voltage. (Default: -6V)  06: Bypass enable/disable when UPS is off Interface Setting Para

12 EN 3-6. Operating Mode Description Operating mode Description LCD display Online mode When the input voltage is within acceptable range, UPS wi

13 EN 3-7. Faults Reference Code Fault event Fault code Icon Fault event Fault code Icon Bus start fail 01 x Inverter output short 14 Bus over

14 EN 4. Troubleshooting If the UPS system does not operate correctly, please solve the problem by using the table below. Symptom Possible cause

15 EN Symptom Possible cause Remedy Battery backup time is shorter than nominal value Batteries are not fully charged Charge the batteries for at l

16 EN 5. Storage and Maintenance Operation The UPS system contains no user-serviceable parts. If the battery service life (3~5 years at 25°C ambi

17 EN 6. Specifications MODEL PowerWalker VFI 1000CRM LCD (L) PowerWalker VFI 2000CRM LCD (L) PowerWalker VFI 3000CRM LCD (L) CAPACITY* 1000 VA /

EN Table of Contents 1. Important Safety Warning ... 1

1 EN 1. Important Safety Warning Please comply with all warnings and operating instructions in this manual strictly. Save this manual

2 EN 1-5. Maintenance, service and faults  The UPS system operates with hazardous voltages. Repairs may be carried out only by qualified maintenan

3 EN 2. Installation and setup NOTE: Before installation, please inspect the unit. Be sure that nothing inside the package is damaged. Please keep

4 EN 2-2. 1-3K Setup the UPS Step 1: External battery connection (Only for long-run models) This UPS is not including batteries. Please connect exte

5 EN Step 4: UPS output connection  For socket-type outputs, simply connect devices to the outlets.  For terminal-type input or outputs, plea

6 EN 2-3. UPS Tower/Rack Installation Rack-mount Installation This UPS can be mounted in the 19” rack chassis. Please follow below steps to positi